So as with my TravelCNC I'm custom making a studio case to keep my Ultimaker II 3d printer safe.
Since the Ultimaker has a nice, white case, the studio case is going to white too.
It will not be sound-proof with Basotect foam but use a hard foam to stand on and keep the Ultimaker II centered and a soft foam for padding.
Note:
You REALLY want to use buy a pneumatic rivet gun for this.
Mounting 150 rivets by hand alone is tiring, very loud and takes weeks.
...as opposed to silent operation (except of cause the compressor recharging since cheap rivet guns take a lot of air volume) of a few hours.
Keine Kommentare:
Kommentar veröffentlichen